How to repair a sex doll
Your sex doll may get some pressure marks when you press her surface with some heavy items or you improperly lay her. In this case, you will be anxious to find some solutions to make it better or completely fix it.
In general, for a sex doll with high quality, if the depth of pressure mark is only 1-3mm, and it will recover when released from the pressure for a while.
If the pressure marks can’t disappear by themselves after several days, and you can try the following two methods
By a hot towel
Cover the pressure dents with a hot clean towel for a while, and then put on your gloves and pat the part with your hands. Repeat them until the indentation disappears.
By a hair dryer
Cover the pressure marks with a wet clean white cloth and then use a hair dryer to heat the surface until the press mark and indentation disappear gradually.
(Note: You don’t have to worry about skin damage because TPE dolls can withstand temperatures as high as 200 degrees Celsius (392 degrees Fahrenheit).)
Recovering the sex doll surface crack
In our daily use, due to improper operation, it is easy to cause damage to the skin of the doll’s surface, such as the sharp objects can result in the rupture of the doll’s skin surface. In this situation, you should take immediate action so that you can easily repair your valuable doll.
Repair tools
TPE glue, mild soapy water/detergent/makeup remover/nail varnish remover, clean cloth, toothpick/cocktail stick, TPE material piece
(Note: You should use exclusive TPE glue for your sex doll repair. The TPE repair glue will melt the TPE and then the melted part will rejoin, so it will help the repaired part to be more natural. You can buy this special glue from Amazon or some TPE sex doll shop like WM and SexySexDoll, the price is about $20 per 10ml.)
Steps to repair
A. For a relatively clean and small tear
1. Clean and dry the damaged part
To help the TPE glue work better, you need to clean the damaged part with detergent, mild soapy water, makeup remover or nail varnish remover.
After cleaning, wipe off the damaged skin with a clean towel/cloth and dry the remaining water thoroughly.
2. Make the damaged part in nature posture status;
To discourage the glue from flowing out of the doll wound, you’d better place the wound site horizontally. You also need to find a position that you can easily hold the two sides of the tear together, with the 2 sides level as possible for about 2 minutes.
3. Spread glue on the damaged part
Open the TPE glue container, dip the toothpick or cocktail stick into the glue. (Try to avoid an excess drop hanging off the end of the stick)
Replace the cap on the glue bottle to prevent solvent evaporating
Rub the toothpick on the inside of the tear, on both inner sides
Gently push the sides of the tear closed, and let the two sides at even level
Wipe away any excess that is squeezed out of the damaged part with a tissue or clean cloth. (Remember, don’t use your finger since it will cause fingerprint impressions on your doll surface)
Keep the tear closed and push the two sides together to push the dissolving TPE sides into one piece of TPE.
Keep together for at least 2 minutes, or until you cannot smell any solvent at the damaged part. (You can blow on the damaged part to promote the evaporation of the glue)
Relax your grip, and wait for about half an hour for the glue to dry.